Image : http://www.flickr.com
Did you accidentally slip your Nintendo DS from the hand (n), where it was hard to the ground and broke a hinge or a nasty scratch visible on your Nintendo DS case? Before you curse yourself peace of mind that you have to replace your Nintendo DS on your case. But beware, it is a difficult task. You need special tools and lots of patience. If you do not think you have what it takes, it is best to send him next in the faithfulShop for repair.
If you have the courage to do this, let's start. If you are calm and ready to conceal screws Nintendo DS case, put a cloth or towel to keep the base and a plate to put in practice
Now turn the DS around so that the rear on the right shows. First remove the two rubber pads on top. Then remove the screw on the battery in the lower right, two more screws on the left side, and the screw tab DSSlot. Remove the battery, remove the screw and the cover and inside. After all the screws on the plate, remove it gently back. Remove all parts from the shell, but be careful if you are removing the shoulder buttons as springs, can jump out.
Take the white and black wires near the DS card slot, and remove the black under the slot on the opposite side. Then remove the screws on both sides. You can view the board from the other half of thethe bottom of the Nintendo DS case.
Remove the two screws at the top ABXY buttons, and turn the black bar above the head pad to rip the ribbon cable and bring it gently down. Remove the power display. Set the cable to the thin slit, the slide show on the left, while at the same time, the pot test properly, the ribbon cable. Now remove the bottom of the upper part of the Nintendo DS case and put it aside.
Turn yourPay attention to upper case. Slip of the angle adjustment on the left side, pull the ribbon cable and remove the ring on the opposite side. Then, look at the top of the screen. There are four screws hidden under pads at each corner around the top of the screen, remove both the cover and screws. It 's a bit tricky, so take your time.
When you are finished, press the top with your thumb on each side of the screen and the index under it and slide it upwards. We recommendOpen in a position at the top shell. Roll the flat edge and press the right smart of him completely. Congratulations! Now you can use any piece of your Nintendo DS case. Please install accordingly reverse.
NOTE: Do not forget to align the switch ON / OFF or you can break your switch!
0 ความคิดเห็น:
แสดงความคิดเห็น