Image : http://www.flickr.com
Have you accidentally slide your Nintendo DS from your hand (s), where he fell to the floor hard and broke a pin or get a nasty scratch visible on your Nintendo DS case? Before the curse, the rest easy that you have to replace your Nintendo DS on your case. But beware, it is a difficult task. You need special tools and lots of patience. When you do not think you do, it is best to send the faithful comingShop for repair.
If you have the courage to do this, let's begin. If you are calm and ready to adjust based on your Nintendo DS case, put a cloth or a towel and keep at hand for a saucer to put in screws.
Now turn around the DS, so the back shows at the top right. First remove the two rubber pads on top. Then remove the screw on the battery in the bottom right, two more screws on the left side, and screw on SD cardSlot. Remove the battery, remove the screw and the cover and inside. After all screws fixed on your plate, remove it gently back. Remove all parts from the shell, but beware, if you remove the buttons as can skip the springs.
Take the white and black wires near the SD card slot, and remove the black under the slot on the opposite side. Then remove the screws on both sides. Now you can get from the other half ofthe bottom of your Nintendo DS case.
Remove the two screws abxy the buttons at the top, and turn the black bar above the head in the direction pad to hold the flat edge and carefully examine it. Remove the power indicator. Insert the flat metal bracket on the Slim, slide show, left and right shell test the flat edge at the same time. Now remove the bottom of the upper part of the Nintendo DS case and put aside.
Turn yourAttention to the top of the box. Slip of the angle adjuster on the left side, pull the ribbon cable and take the ring on the side. Next look at the top of the screen. There are four screws under the pads at each corner around the top of the screen to remove hidden, both the cover and screws. It's a bit 'tricky, so take your time.
When finished, press the top with your thumb on each side of your screen and your index finger down and slide it upwards. We recommendopen position of the upper shell. Roll the flat edge and push the right way to remove it completely. Congratulations! You can now every bit 'of your Nintendo DS case. Please install according to the back.
WARNING: Do not forget to align the switch ON / OFF or you can break your switch!
0 ความคิดเห็น:
แสดงความคิดเห็น